Sys Tec Electronic GW-003 - Configuration and Operation Using Telnet

CAN – Ethernet Gateway
22 © SYS TEC electronic GmbH 2007 L-1032e_9
3.5.3 Configuration and Operation using Telnet
Configuration of the CAN-Ethernet Gateway during operation is also
possible via Telnet (TCP port 23). The function parameters are the
same as those of the RS-232 interface. Use of Telnet also enables
configuration of remote CAN-Ethernet Gateways. A condition for this,
however, is the initial configuration of the IP address with the
command
ipcfg (refer to section 4.5.12). Without this initial
configuration of the IP address the CAN-Ethernet Gateway can only
be addressed via its standard configuration (refer to section
3.5.1).
A Telnet client is already included in the Windows package. This
Telnet client can be called via
telnet <Address>. Under Linux the
programs
telnet or netcat can be used.