Delivery, transport, storage |
3
♦ Make sure that there is nobody under a suspended load.
4.2 Delivery
Each fan leaves our plant in an electrically and mechanically proper condition. We recommend transporting the fan to
the installation site in the original packaging.
Checking delivery
♦ Check completeness of the delivery.
♦ Check the packaging for transport damage.
Unpacking
Warning
When opening the transport packaging, there is a risk of damage from sharp edges, nails, staples,
splinters etc.
♦ Unpack the fan carefully.
♦ Check the fan for obvious transport damage.
♦ Only remove the packaging shortly before assembly.
♦ Wear protective equipment during all work in the vicinity of the fan, details see 2.2 Personal protective
equipment, page 2.
4.3 Transport
4.3.1 Safety information
Warning: Electrical or mechanical hazards due to fire, moisture, short circuit or malfunction.
♦ Never transport the fan by the connecting wire, terminal box, rotor, protective grille, inlet cone or silencer.
♦ In open transport, please make sure that no water can penetrate into the motor or other sensitive parts.
♦ We recommend transporting the fan to the installation site in the original packaging.
Caution: If transported without care during loading and unloading, the fan may be damaged.
♦ Load and unload the fan carefully.
♦ Use hoisting equipment that is suitable for the weight to be hoisted.
♦ Observe the transportation arrows on the packaging.
♦ Use the fan packaging exclusively as transport protection and not as a lifting aid.
4.4 Storage
4.4.1 Safety information
Warning: Risk of injury and damage to the fan.
♦ Do not stack the fans on top of one another.
♦ Do not use transport packaging as hoisting aids.
♦ Use hoisting equipment that is suitable for the weight to be hoisted.
4.4.2 Preconditions
♦ Store the devices in a clean, dry and vibration-free environment.
♦ Storage temperature should be between –20°C and 60°C.
4.4.3 Long storage time
Storage more than 3 months
♦ Turn the rotor at least 10 revolutions once a month.
♦ Please ensure that the rotor is at a different position afterwards.
| 003
To Next Page
Loading...
Need help?
General