44
Road transport
Right wheel in trans-
port position
The right wheel must be in transport position.
> Remove the locking pin
> Remove the pin
> Place the wrench on the hexagon bolt
> Use the wrench to turn the wheel into transport position
> Place the pin
> Place the locking pin
> Remove the wrench
Checking the ma-
chine
Check the machine before road transport by means of the checklist:
• The tractor hydraulic is switched off?
• All valves are closed?
• Crop residues and heavy dirt are removed?
• Cables and lines are placed in that way they will not tension or get
in touch with the tractor rear tyres during curve driving?
Road transport
• Before starting driving, check the close environment. Always take
care of a clear view and especially at children in the working envi-
ronment of the machine.
• Lock the hydraulic valves of the tractor before road transport
• Do not transport any persons or objects at the machine
• Adapt the drive speed to the road conditions
• Do not exceed the maximum speed of 25 km/h. Obey the national
and local speed limits.
• Pay attention to sufficient driving and braking capacity. Then driv-
ing and braking capacity are influenced by the attached machine
(longer braking paths because of larger driving power).
Locking pin Pin
Transport position Hexagon bolt
Wrench
To Next Page
Loading...