58
Electronic control system
Control mode
The electronic control system can be used in the following control
modes:
• manual mode
• semi-automatic mode
• automatic mode
The set of parameters determines working in semi-automatic or auto-
matic mode.
Manual mode
In manual mode, the wrapping cycle is controlled by the toggle switch-
es and the joystick.
> Push to select manual mode
Depending on the requested action
> Push the concerning toggle switches or joystick on the control box
Semi-automatic
mode
Semi-automatic mode offers the possibility for the following:
• to stop the table before film wrapping starts
• to stop before bale unloading
> Push to select semi-automatic mode
When one or more of the above-mentioned adjustments are selected,
the wrapping cycle will stop at the concerning point(s).
> Push to set the desired parameter
> Push to continue wrapping
To Next Page
Loading...