66
Cleaning and caring
Cleaning and cari ng
Safety
For all cleaning and caring activities applies:
Do not penetrate bearings and hydraulic parts
Be careful when cleaning with a high-pressure cleaner. Bearings,
sealings and bolted joints are not waterproof. To avoid machine dam-
ages never penetrate bearings, sealings and bolted joints with water.
Do not clean bearings and hydraulic parts with high pressure
Do not clean bearings and hydraulic parts with a high-pressure clean-
er. Bright metal parts will get degreased and start rusting. After every
cleaning grease the bearings and grease bright metal parts.
Cleaning
After every time of using the machine:
> Empty and clean the machine of all accumulated crop
Cleaning can be done with low pressure with the high-pressure clean-
er. Do not clean bearings, electronic and hydraulic parts with the high-
pressure cleaner.
Pre-stretcher rollers
The pre-stretcher rollers must be cleaned from particles, dust, crop
and tack.
> Use methylated spirit or similar to clean the rollers
After cleaning
After cleaning with the high-pressure cleaner
> grease all bearings
Caring
When you observe the rules below, you will have a fully operational
machine at the start of the next season:
> Protect all bright metal parts with an oil film. Only use authorized
biological oil, like rape oil
> Repaint any paint damages
To Next Page
Loading...