Taarup 7420 - Parameter Settings

Wrap and bale counter
53
Parameter set-
tings
Via the parameter settings, the entire wrapping process is prescribed.
CYK
The current number of table laps can be set. The pre-set number of
table laps can be shown in the display.
> Push to enter the display CYK
> Push until the current number of table laps flashes
> Push to set the first digit
> Push for the last digit
> Push to set the last digit
> Push to confirm
BAL
The number of bales wrapped can be shown in the display. The num-
ber of bales wrapped can be reset to zero.
> Push to enter the display BAL
> Push until the number of bales wrapped flashes
> Push to reset to clear the number of bales wrapped to zero
> Push to confirm
Number Recommended number
2 - 99 → Film wrap recommendations, page 48
Number
0 - 99999