Taarup 7420 - Parameter Settings

Electronic control system
61
Parameter set-
tings
Via the parameter settings, the entire wrapping process is prescribed.
CYC
The number of table laps can be set.
BAL
The number of bales wrapped.
The number of bales can be reset
> Push to confirm
Now the total number of jobs increases with one.
→ JOBS, page 61
BAL +
The total number of bales wrapped.
The total number of bales wrapped can not be reset
JOBS
The total number of jobs done.
The total number of jobs can be reset to zero
> Push to confirm
After the number of bales has been cleared to zero, the total number
of jobs done increases with one.
Number Recommended number
1 - 100 no recommendation
Number
0 - 99999
Number
0 - 99999
Setting
0 - 99999 Can be cleared to zero