62
Electronic control system
A. on / A. off
A buzzer can be switched on or off for
• a sound after the last sensor by-pass
• when an error occurs
A1:1 / A1:0
This setting is only valid in case your machine is equipped with the
electronic control system.
The bale loading with the loading arm can be included in the wrapping
procedure.
A2:1 / A2:0
This setting is only valid in case your machine is equipped with the
electronic control system.
The start of film wrapping after bale loading.
After the bale is loaded
> Push to confirm
Setting Buzzer
• +
• -
• on
• off
Setting Recommended setting
• 1 = yes
• 0 = no
1
Setting Recommended setting
• 1 = start
• 0 = stop
1
To Next Page
Loading...