Electronic control system
63
A3:1 / A3:0
The bale unloading can be included in the wrapping procedure.
If ‘0’ is chosen, a new loading and wrapping cycle can be started
> Push to confirm
A4:1 / A4:0
The bale unloading can be done immediately after the wrapping cycle
is finished.
If ‘0’ is chosen, the bale unloading can be done manually
> Push to confirm
A6:1 / A6:0
This setting is only valid in case your machine is equipped with the
loading position sensor.
After bale unloading the table turns 90°.
A7:1 / A7:0
Independent on an optional film sensor is mounted, this setting must
be used.
Setting Recommended setting
• 1 = yes
• 0 = no
1
Setting Recommended setting
• 1 = yes
• 0 = no
0
Setting Recommended setting
• 1 = possible
• 0 = impossible
1
Setting Recommended setting
• 1 = mounted
• 0 = not mounted
0
To Next Page
Loading...