Taarup 7420 - Maintenance intervals

Maintenance
71
Maintenance inter-
vals
Before doing any maintenance, the following must be obtained:
• Clean the machine before doing any repair work
• Never work on the machine while it is running
• The tractor engine must be switched off and the ignition key must
be removed
• Clean the machine with a compressor
After the first working hour
After the first 8 working hours
After the first 50 working hours
Every 10 working hours Every 15 working hours Every 50 working hours
Every 150 working hours Every 200 working hours
Every week
Once per season
Grease
Oil
Check
Tighten
Change
Page
Attaching elements
Screwing bolts tighter
• • • • •
72
Special torques
•• • ••
72
Pre-stretcher
Checking the pre-stretcher rollers
••••
74
Wheels/tyres
Tyre pressure
•••
75
Hydraulics
Hydraulic hoses 76
Filter hydraulic block
• •
76
Filter hydraulic block
••
76
Table
Drive chain tension
••
77
Table lock adjustment 77
Applicutter
Applicutter knife replacement
•
78
Catch rod adjustment 78
Cutting time adjustment 79
Lubrication
Motor gear
• •
80
Gear ring
••
80
Table roller drive chain
• • •
80
Table sprocket
••
81
Tipping frame hinges
• •
81
Loading arm hinge
••
81
Loading arm cylinder
• •
81
Wheel hubs
••
82
Wheel arm right
• •
82
Applicutter
••
82
Catch rod applicutter
• •
82
Pre-stretcher gears
••
83