56
Electronic control system
Buttons
Auto button
• Selection of automatic mode
Stop button
• To stop, interrupt a procedure. Rotation of the table is interrupted.
• Selection of manual mode
Programme mode button
• Programming functions
• Counter reset
To neutral position
The loading arm is moved to its neutral position, in front of its sensor.
To start point
To:
• move the loading arm to the middle position
• move the table fully downwards
• reset the revolution counter to zero
Pushing to
• increase a value
• switch the buzzer on
Pushing to
• decrease a value
• switch the buzzer off
Table to bale loading position
This is only possible, if the loading position sensor is mounted on the
machine.
To Next Page