90
Troubleshooting
The film is not retained • Too less pressure on the roll-
er
• The roller is dirty
• The retainer is worn
• Catch rod L releases too late
> Check the distance, 4-5 mm
> Check whether there is play
between guide rollers A and
catch rod L
> Check whether roller B is
clean; there must be no oil
on the outside
> Check the retainer for wear
and tear
> Replace if necessary
> Adjust by means of washers
under catch rod stopper A
so, that the distance be-
tween the edge of the end
plate and the knife assembly
is 2-3 mm
Problem Cause Solution Page
To Next Page
Loading...