TAC 2112 User Manual

TAC 2112, Manual Using the Operator´s Panel
3:2(6), 0-004-7459-3 (GB) 1999-08-01, TAC AB
3.2.1 Parameter numbers and parameter values
The controller has a list of 100 parameters numbered from 0 to 99.
Some of these parameters can be set (such as the setpoint for supply
temperature), while others can just be read (such as the outdoor
temperature). Some parameters cannot be displayed if the
corresponding function is blocked. For example, the room
temperature will not be displayed if there is no reference sensor.
The parameter numbers and parameter values in the display window
constitute a “window” to the list of parameters.
P 18 Reset curve (x1)
P 19 Reset curve (y0)
P 20 Reset curve (y1)
1
2
5
6
7 8 9 1011121314151617
18
0
23
22
19
24
K1
MO
3
4
P 22
21
20
°C
10.0
P 24 P band, supply c.
P 25 Run time, actuator
P 26 Max. increase rate
List of parameters
Display window
Parameter
number
Parameter
value
Window
up
Window
down
The display window constitutes a window to the list of parameters
The buttons and are used to move the “window” up and down
over the list of parameters.

TAC 2112 Specifications

General

Brand	TAC
Model	2112
Category	Controller
Language	English