Need help?Do you have a question about the TAC 2413 and is the answer not in the manual?
Provides a short introduction to the controller and its handbook.
Explains how to utilize the handbook for installation, commission, and use.
Lists the documents supplied with the controller for installation and commissioning.
Describes the controller's role in monitoring and supervising air handling units (AHUs).
Guides users on operating the panel to read and set parameters.
Explains the information displayed on the AHU operator panel.
Details the functionality of the five buttons on the operator's panel.
Provides information for handling the controller during normal operation.
Explains the procedure for reading various temperature parameters.
Guides users on how to set temperature parameters.
Details how to set weekly programs for timed AHU operation.
Explains how to read and reset alarms on the controller.
Describes how to select different operating modes for the AHU.
Provides instructions for setting the controller's clock and date.
Details how to position and mount the controller unit.
Explains how to connect cables to the controller based on the wiring diagram.
Locates and describes the terminal blocks on the back of the controller.
Specifies the maximum allowed lengths and cross-sectional areas for cables.
Outlines the steps required before switching on the power for commissioning.
Introduces the chapter describing all controller functions and parameters.
Explains the different operating modes: timed, manual, and off.
Details the functions related to air handling, including fan operation.
Describes the controller's calendar clock functions, including summer time.
Explains the weekly and yearly timer programs for AHU control.
Details the controller's built-in alarm functions and types.
Explains that parameters are stored permanently in the controller's memory.
Describes the procedure for restoring factory settings.
Lists measurement ranges and deviations for thermistor inputs.
Specifies maximum voltage and current for relay outputs.
Lists sensory inputs and remote setpoint control inputs.
Lists the types of relay and analog outputs.
Details the DIP switch settings for controller configuration.
Explains the steps to select and change parameter values.
General| Brand | TAC |
|---|---|
| Model | 2413 |
| Category | Controller |
| Language | English |
To Next Page
