1:2 (4), 0-004-7614-0 (GB) TAC AB, 1998-10-23
TAC 2413 Handbook This handbook
Index
At the end of the handbook, you will find an index containing
page references.
1.2 How you may use this handbook
The TAC 2413 Handbook describes all the functions and procedu-
res that are needed to install, commission and use the controller.
The TAC 2413 controller, as well as other products in the
TAC 2000 family, must not be used for purposes other than that
which it was constructed for.
The installation, connection and maintenance is required to be
performed by authorized staff.
During normal operation
If you are only going to read or set temperatures and other para-
meters during normal operation, it is sufficient to read Chapter 3,
Using the operator’s panel, and Chapter 4, Day-to-day usage.
You may also make use of the Quick Reference which is located
on the front of the controller.
During installation and commissioning
If you are going to install and commission the controller, you
should read Chapter 5, Installation. The document which is in-
cluded with the controller, TAC2413 Installation instructions, may
be used for this purpose as well. The commissioning protocol is
included in that document, but it is appendix A in this handbook
as well.
During troubleshooting
When there is something wrong with the controller, you should
read Chapter 3, Using the operator’s panel, Chapter 4, Day-to-
day usage and Chapter 6, Troubleshooting.
1.3 Documentation for the controller
Enclosed documentation
The documents below are supplied with the controller. They con-
tain all the information you need to be able to install and commis-
sion the controller.
• TAC2413 Installation instructions/Commissioning protocol
(part number 0FL-3891)
• TAC2413 Quick Reference (part number 0FL-3898)
To Next Page
Loading...
Need help?
General
