TB8100 Installation and Operation Manual Preparation for Operation 127
© Tait Electronics Limited June 2005
8 Preparation for Operation
Once the TB8100 BSS has been installed and connected, it is time to
prepare it for operation. The main procedures required to ensure your BSS
is ready for operation are as follows:
■ tuning
■ configuration
■ applying power
■ test transmissions.
The following sections provide more detail on these procedures. Some
sections provide only an overview, as the full procedures are described in
other documents.
8.1 Tuning
If you have not already done so, you must tune the TB8100 BSS reciter
modules before operating them in your radio system. To do this you will
need to use the Calibration Kit software included on the Product CD, plus
the TB8100 calibration test unit (CTU).
Refer to the Calibration Kit documentation for full details on the tuning
procedures.
8.2 Configuration
Software The TB8100 BSS can be configured using software to operate in many
different ways. Although it is programmed with a default configuration at
the factory, you will need to use the Service Kit software to configure your
BSS to suit the requirements of your radio system.
Refer to the Service Kit and its associated documentation for full details of
all the options available in the complete configuration process.
Note The BSS will be programmed at the factory with default pass-
words which you will need to use to log on for the first time.
Refer to the Service Kit Help for more information on these pass-
words and how to change them.
To Next Page
Loading...
