TB8100 Installation and Operation Manual Connection 103
© Tait Electronics Limited June 2005
7 Connection
Once the TB8100 BSS hardware is installed, you need to connect the
individual modules to each other, and to any ancillary equipment required
in your system. This chapter provides information on all the inputs and
outputs available on the TB8100 BSS.
7.1 Overview of Inputs and Outputs
This section identifies the main input and output connections for the
TB8100 BSS.
■ Figure 7.1 on page 104 identifies the connections at the front of a dual
base station, and Figure 7.4 on page 107 identifies those at the rear.
■ Figure 7.2 on page 105 identifies the connections at the front of a dual
12V PA base station, and Figure 7.5 on page 108 identifies those at the
rear.
■ Figure 7.3 on page 106 identifies the connections at the front of a single
100W base station.
■ Figure 7.6 on page 108, and Figure 7.7 and Figure 7.8 on page 109
identify the connections on the standard, dual base station, and Power
Save control panels.
Refer to the following sections in this chapter for more details on these
connections.