TB8100 Installation and Operation Manual Preparation for Operation 129
© Tait Electronics Limited June 2005
8.4 Test Transmissions
Once you have completed the procedures described in the previous sections,
you may want to make some test transmissions. These will verify that your
TB8100 BSS is operating correctly.
Note You may wish to have the Service Kit software running during
these tests so that you can monitor the performance of the BSS.
1. Ensure that the BSS is correctly connected to an appropriate antenna
and that all RF connectors are secure.
1. Plug the microphone into the RJ45 socket on the control panel (refer
to “Control Panel” on page 28).
2. Select the base station you wish to transmit on with the microphone
channel button.
3. Turn on the speaker audio for the selected base station with the
speaker button.
4. Press the PTT switch on the microphone and make your
transmission. Check that:
■ the red transmit LED turns on
■ there are no alarms generated
■ the audio quality on the receiving radio is good.
5. When the other radio answers your transmission, check that:
■ the green receive LED turns on
■ the audio quality from the speaker in the control panel is good
(adjust the speaker volume as required).
To Next Page
Loading...
