TB8100 Installation and Operation Manual Installation 75
© Tait Electronics Limited June 2005
5.2.2 Antenna Load
Important The PA may be damaged if the load is removed or switched
while the PA is transmitting.
To protect the PA output stage from load transients (i.e. switching or
removing the load), we recommend that you fit an isolator between the PA
and the load. Fit the isolator as close as possible to the RF output connector
on the PA. Do not connect any switching or combining equipment
between the isolator and the PA.
5.2.3 Equipment Grounding
To ensure safe operation the TB8100 BSS equipment must be correctly
grounded as described in these installation instructions.
5.2.4 Installation and Servicing Personnel
The TB8100 BSS should be installed and serviced only by qualified
personnel.
5.3 Regulatory Information
5.3.1 Distress Frequencies
The 406 to 406.1MHz frequency range is reserved worldwide for use by
Distress Beacons. Do not program transmitters to operate in this frequency
range.
5.3.2 FCC Compliance
1
This device complies with part 15 of the FCC Rules. Operation is subject
to the condition that this device does not cause harmful interference.
5.3.3 Unauthorised Modifications
Any modifications you make to this equipment which are not authorised by
Tait Electronics Ltd may invalidate your compliance authority’s approval to
operate the equipment.
1. Refer to the TB8100 Specifications Manual for more information on the compliance standards to
which the TB8100 BSS equipment has been tested and approved.
To Next Page
Loading...
Need help?
General
