130
MAINTENANCE
When Required
Travel levers, blade lever and pedals
1. Remove the floor mat (1).
2. Remove the lower mount section of the
boot (2) and roll it up.
3. Loosen the bolts and remove cover (3).
4. Use the grease gun to supply grease to
the grease nipples (4).
5. Wipe off the expelled grease.
6. Reinstall the cover and floor mat, following
the removal procedure in reverse order.
7. Tilt up the platform.
Refer to “Tilting Up the Platform”.
8. Use the grease gun to supply grease to
the grease nipples (5).
9. Wipe off the expelled grease.
Tilting Up the Platform
For inspection and maintenance, the platform
is designed so that it can be tilted up.
WARNING
¡¡
¡¡
¡Raising or lowering the platform while
the engine is running may cause the
machine to move, and cause serious
injury or death. Stop the engine before
raising or lowering the platform.
¡¡
¡¡
¡When the platform is tilted up, support
it firmly with the stopper to prevent it
from falling.
IMPORTANT: Lower the working
equipment to the ground before raising
the platform. If not avoided, could result
in the boom from touching the cab.
Raising (Tilt up)
1. Select a firm, level surface, set the
machine to the posture shown in the
diagram above, ground the working
equipment, then stop the engine.
2. Raise the safety lock lever(s) to engage
the lock.
Close the cab door (cab).
G4G024
1
4 3 2 4 5
G4G025
1 4 2 4 3
5
5
To Next Page
Loading...
Need help?
General
