94
MAINTENANCE
Service Data
Fuel and Lubricant Chart
Use different fuels, lubricants and greases according to the temperature, referring to the chart below.
¡Change the lubricant earlier than as shown in the table if it is extremely dirty or its
performance has deteriorated severely.
¡Whenever possible, use the same brand of lubricant as before. If changing with a different
brand, replace the entire quantity – do not mix different brands.
{ } : Serial No. 14515346 ~
< >: for the tropics Serial No.14517254~
Part
Type
Type by temperature
-22 -4 14 32 50 68 86 104°F
-30 -20 -10 0 10 20 30 40°C
Replacement
interval
Capacity
R(US. qt.)
Engine
oil pan
Diesel
engine oil
API-CD
After first 50 hrs.
Every 250 hrs.
Upper limit:
TB125:3.6(3.8)
TB135:4.7(5.0)
TB145:7.4(7.8)
Lower limit:
TB125:2.4(2.5)
TB135:2.9(3.1)
TB145:4.0(4.2)
System:
TB125:74(78.2)
TB135:85(89.8)
TB145:115(121.5)
Tank:
TB125:48(50.7)
TB135:48(50.7)
TB145:74(77.9)
Hydraulic
tank
Antiwear
hydraulic oil
(Option:
Biodegrad-
able oil)
Every 2000 hrs.
Use a clean, Quality fuel for good performance and optimum engine life.
¡ To prevent fuel flow problems in cold weather, use diesel fuel with a pour point of at
least -12°C (10°F) below the lowest expected ambient temperature.
¡ Minimum cetane number is 45. Low temperature or high altitude operation may
require the use of fuel with a higher cetane number.
Fuel tank Diesel fuel
Tank:
TB125:51(53.6)
TB135:51(53.6)
TB145:73(76.6)
Engine
cooling
system
Coolant
(water +
coolant)**
50% coolant mixture
30% coolant mixture
Every 1000 hrs.
TB125:3.5(3.7)
TB135:5.4(5.7)
TB145:6.7(7.1)
{TB145:9.6(10.1)}
<TB145:10.6(11.2)>
SAE 5W-20
SAE 10W-30
SAE 15W-40
Travel
reduction
gear
Gear oil
API-GL-4
SAE 90
After first 100 to
250 hrs.*
Every 1000 hrs.
Slew
bearing
Working
equipment
Levers
Lithium
based
grease
EP-2
NLGI No. 2
Every 50 hrs.
Daily or every
10 hrs.
When
required
As
required
TB125:0.5(0.53)
TB135:0.6(0.63)
TB145:0.8(0.85)
{TB145:1.0(1.06)}
ISO VG32
ISO VG46
ISO VG68
To Next Page
Loading...
Need help?
General
