239
OPTIONS
When equipped with accumulator.
Releasing the residual pressure
After using the auxilliary hydraulic circuits,
pressure remains in the circuits. This is called
the residual pressure. Release this residual
pressure before disconnecting the lines.
1. Stop the engine.
2. Turn the starter switch to the ON position.
3. Fully lower the safety lock lever.
4. Within 5 minutes after the engine comes
to a complete stop, move the 2nd auxiliary
hydraulic switch to the right and left several
times.
5. Place the safety lock lever to the lock
position.
Operating Levers (with Second auxiliary hydraulics) / TB145
C
D
K3L024
To Next Page
Loading...
Need help?
General
