58
CONTROLS
Accessories
(15) DISP (Time/Frequency) button
This system is equipped with a clock which
can show the accurate time. Even if the radio
is off, the clock still shows the time.
(16) PS/AS switch
Pushing this button for 2 seconds down will
automatically operates to show the
memorized station from 1 to 6. The signal
scanning start by pushing this button
momentarily. When a station is received the
scanning automatically stops there for 5
seconds FLASHILY and then resumes
scanning. As soon as the desired station is
found, press the this button again.
If you will auto memory push this button
over 5 sec so initiates a scan of the band.
Station frequencies are either stored in
order of low of frequency for FM, or in
sequence for AM, starting from preset
channel 1. If all of the preset channels have
not been filled up after one scan, the
remaining preset channels are left
unchanged, and channel 1 is recalled.
Channel 8 flashes during A.
¡¡
¡¡
¡Set the time
After pressing DISP button, press tuner
button
or to correct the time. Press tuner
button to set the “hour” and tuner button
for setting the “minute”. Set the time when
the time is shown.
C4C023
To Next Page
Loading...
Need help?
General
