Tandy 1000 MS-DOS - Page 229

: '
r-'
,
,....,
, I
I '
, 1
. ,
• I
Chapter 10 / EDLIN Command Reference
Delete Lines (D)
[linel] [,line2]D
Deletes linel or all lines within the range linel to line2 from a
file.
EDLIN automatically renumbers
the lines to maintain consecu-
tive numbering
in the file.
Parameters
You can omit the linel parameter:
,line2D I ENTER I
If you do, EDLIN starts deleting at the current line and ends at
line2. Your command line must include the comma before line2
to indicate you are omitting linel.
You can omit the line2 parameter:
line 1D I ENTER I or
linel,D I ENTER I
If you do, EDLIN deletes only linel.
If you omit linel and line2, EDLIN deletes only the current line.
D I ENTER I
213