Tandy 1000 MS-DOS User Manual

i
I
l _
,.--,
l
Chapter 14/ Problems and Error Messages
Bad command
MS-DOS issued an invalid command for the device driver. Try
the command again. If it continues to fail, contact the dealer
from whom you bought
the device driver.
Bad unit
A device driver passed an invalid sub-unit number. Contact the
dealer from whom you purchased
the device driver.
Data
The data cannot be read or written correctly. You probably have
a flawed disk.
Disk
r MS-DOS has found an error it does not recognize.
FeB unavailable
L__ FCB's might not be high enough.
,...,
I
l _
r-'
I :
.....-,
l '
r-'
I .
r
!
General failure
A hardware error or the disk is not formatted.
Invalid disk change
A diskette was removed while files were open.
Lock violation
All or part of a source file is locked and cannot be read. Wait a
few moments and try again.
No paper
The printer is out of paper.
Non-DOS disk
The disk is not in a format recognizable by MS-DOS.
Not ready
The device is not ready. Check to see that the drive latches are
closed and that all devices are on and ready.
295

Tandy 1000 MS-DOS Specifications

General

Brand	Tandy
Model	1000 MS-DOS
Category	Desktop
Language	English