Tandy 1000 MS-DOS User Manual

Chapter 14/ Problems and Error Messages
Disk full _ write not completed
You entered the End command, but the disk does not contain
enough free space
for the whole file. EDLIN terminated the End
command and
returned you to the operating system. Some of the
file may have been written to the disk.
Only
part (if any) of the file is saved. Delete that part of the file
and
restart the editing session. The file is not available after
this error. Before you begin any editing session, be sure the disk
has sufficient free space
for the file.
Entry Error
The last command typed contained a syntax error. Reenter the
command, using the correct syntax.
File Creation Error
The EDLIN temporary file cannot be created.
Verify
that the directory has enough space to create the tempo-
rary file. Also be sure that the file does not have the same name
as a subdirectory
in the directory where the file to be edited is
located.
File name must be specified
You did not specify a filename when you started EDLIN. Specify
a filename whenever you
start EDLIN.
File not found
The filename specified during a Transfer command was not
found.
Specify a valid filename when issuing a Transfer
command.
Insufficlent memory
There is not enough memory to run EDLIN.
Free some memory
by writing files to disk or by deleting files
before
restarting EDLIN. Use the Write command and then the
Append command.
Invalid drive name or file
You specified an illegal drive or filename when you started
EDLIN. Specify a legal drive or filename.
306
, .
1 ;
I
I~
,
'--

Tandy 1000 MS-DOS Specifications

General

Brand	Tandy
Model	1000 MS-DOS
Category	Desktop
Language	English