2-12
CONTROLS
Models C712/C713
Controls
2
Software Update
This option allows the machine's firmware to be updated.
Selecting this option will display a screen asking ARE
YOU SURE?
Figure 2-50
Pressing the Up Arrow button moves the arrow to Yes.
Pressing the SEL button will start the update process.
Figure 2-51
Reset to Default
The Reset to Default option will allow the service
technician to clear all RAM memory. This screen was
added because it will not be possible to remove the RAM
chip on future iterations of the UVC3 control. The
machine must be in a Unit Cleaned status in order to
restore the default settings. Selecting this option in the
menu will display a screen asking ARE YOU SURE?
(See Figure 2-52.)
Figure 2-52
Moving the cursor to YES and selecting the Calibration
button will restore all factory default values.
SOFTWARE UPDATE
ARE YOU SURE?
> YES
NO
RESET TO DEFAULT
ARE YOU SURE?
> YES
NO
To Next Page
Loading...
Need help?
General
