30
Controls and Systems
McDonald's Intelligap Grills
130731
n. The AUTO GAP screen will display. This screen
shows two sets of numbers. The first set of
numbers is the minimum gap and second set of
numbers is the maximum gap of the item.
10:1 - CLAM
AUTO GAP: 230 TO 330
o. Adjust the setting of the 1
st
set of numbers by
performing Steps 2 - 4 from the Remove Gap
section on page 25. After pressing the OK key,
the cursor moves to the 2
nd
set of numbers.
Repeat the procedure to adjust the 2
nd
setting.
p. The screen will display “AM __ PM __”. Use the
keys to scroll to the appropriate
selection and press the key.
Removing Optional Menu Items
Core menu items cannot be removed. However,
menu items programmed using the “ADD ITEM”
menu option can be removed .
Step 1
Press the key for “MENU ITEMS”.
Step 2
Use the keys to scroll to menu item to
be removed.
Step 3
Press the key until “REMOVE IN” displays.
Step 4
Press and hold the key for 5 seconds, until the
menu item is removed.
Factory Default Settings Reset
Procedures
Perform the following steps to reset the control to
the factory default settings. This feature is available
on software version 2.78 and higher.
Note: Resetting to defaults will default the control to
the 3 platen electric configuration. To reset to a
different configuration (example: 2 platen control),
the setting must be changed in System Set Up.
Step 1
Place the power switch in the ON position and wait
for the control to display “OFF.”
Step 2
Press the key once. Then press the following
keys in succession: .
The following screen will display.
PRESS ENTER FOR
MENU ITEMS
Step 3
Press and hold the key for 5 seconds until the
following screen displays.
RESET CORE MENU?
NO
To Next Page
Loading...
Need help?
General
