OPERATING PROCEDURES
6-15
Model C708 - WAWA
Operating Procedures
6
1. Remove the handscrews, freezer door, beater,
scraper blades, and driveshaft with driveshaft seal
from the freezing cylinder.
2. Remove the driveshaft seal from the driveshaft.
(See Figure 6-47.)
Figure 6-47
3. Remove the freezer door O-ring, front bearing, pivot
pin, draw handle, and draw valve. Remove the three
O-rings from the draw valve.
4. From the pump cylinder, remove the retaining pin,
liquid valve body, piston, mix inlet tube, spring, and
poppet. Remove all O-rings and check rings.
(See Figure 6-48.)
Figure 6-48
5. Remove the pump driveshaft from the drive hub in
the rear wall of the mix hopper. (
See Figure 6-49.)
Figure 6-49
6. Remove the two small O-rings and one large O-ring
from the pump driveshaft.
7. Remove the front drip tray and splash shield.
8. Remove the drip pans and take them to the sink for
cleaning. (
See Figure 6-50.)
Figure 6-50
Note: If the drip pans are filled with an excessive
amount of mix, it is an indication that the driveshaft seal
or O-rings should be replaced or properly lubricated.
To Next Page
Loading...
