The Looper
VL3X – Reference manual (updated 2015-07-16) 135
► Select the option you want to use by tapping
the respective footswitch.
► Press BACK to exit the INPUT menu.
Save
► Tap SAVE (Reverb footswitch) to store your
loop to the current Loop Slot.
The current Loop Slot number is shown below
the UP and DOWN arrows on the far left of the
Loop display.
► To switch to another Loop Slot, press the Pre-
set up and Preset down footswitches.
The Loop Slot number is saved with your oth-
er Preset information and is automatically re-
called when you load a Preset.
► Undo/Redo information is NOT stored with the
Loop when saved.
Saving your Loop to the current Loop Slot
Metronome sub-menu
Tap MET (the HIT footswitch) to enter the Metro-
nome sub-menu. In the Metronome sub-menu,
you can turn the metronome on or off and
change its sound.
Metronome sub-menu
The options in the Metronome sub-menu are:
► MET ON: Tap MET ON (Double / Comp
footswitch) to turn on the metronome and all
related sync features.
The Metronome is more than a simple “click
track”. It generates an audio signal guiding
you when you are recording loops – but it also
syncs with and controls the tempo.
► MET MUTE: Tap MET MUTE (Harmony / Drive
footswitch) to mute the audio output for the
Metronome. If you mute the Metronome, it will
still be active for tempo and LoopAssist™, but
it won’t make any sound.
► MET OFF: Tap MET OFF (Delay footswitch) to
turn off the metronome and all related sync
features.
Please note the difference between MET OFF
and MET MUTE: When you turn the Metro-
nome off, VL3X’s LoopAssist™ no longer
guides your recordings, and the Loop may fall
“off time” with other time based effects like
Delay or Rhythmic.
To Next Page
Loading...
Need help?
General
