Getting to know VL3X
VL3X – Reference manual (updated 2015-07-16) 64
Ins(ert) / Del(ete) (assigned
to Mix Knob 3)
► Turn Mix knob 3 clockwise (right) to insert an
empty character (a blank) to the left of the cur-
rently highlighted character.
► Turn Mix knob 3 counter-clockwise (left) to the
left to delete the currently highlighted charac-
ter.
Store to (assigned to Mix Knob 34)
Use Mix Knob 4 to select the Preset number
where the current Preset will be stored.
► If you want to save the Preset where it current-
ly is, do not change this value.
► If you would like to save the Preset to another
location, change “Store To” to another num-
ber.
The name of the selected Preset slot will be
displayed in the upper part of the screen.
Using Store To is handy when you would like to
make several Presets with similar sounds. You
can create a “master” Preset and store it so a
few different locations using Store To. You can
then edit those copies further if you wish.
Store menu
When you are finished naming and assigning
your Preset, simply press Store again to com-
plete the operation.
Storing Presets and HIT Behavior
When you have set HIT Behavior to “Snapshot”
mode, you must save the Preset for each HIT
state – on and off – in order for your changes to
be stored. Prepare both variations of the Preset
(on and off) and store them, like this:
► Turn HIT off.
► Turn the effects on that you would like to use
when HIT is off.
► Press the Store button twice.
► Turn HIT on.
► Turn the effects on that you would like to use
when HIT is on.
► Press the Store button twice.
To Next Page
Loading...
Need help?
General
