TDK-Lambda Z10-20 - Page 7

3.9.3 Wire Termination ..................................................................................................................................................... 31
3.9.4 Noise and Impedance Effects .......................................................................................................................... 31
3.9.5 Inductive Loads ........................................................................................................................................................ 31
3.9.6 Making the Load Connections ........................................................................................................................ 31
3.9.7 Connecting Single Loads, Local Sensing (default) .............................................................................. 33
3.9.8 Connecting Single Loads, Remote Sensing ............................................................................................ 33
3.9.9 Connecting Multiple Loads, Radial Distribution Method ............................................................... 33
3.9.10 Multiple Load Connection with Distribution Terminals ................................................................ 34
3.9.11 Grounding Outputs .............................................................................................................................................34
3.10 Local and Remote Sensing ..........................................................................................................35
3.10.1 Sense Wiring ............................................................................................................................................................. 35
3.10.2 Local Sensing ........................................................................................................................................................... 35
3.10.3 Remote Sensing ..................................................................................................................................................... 36
3.10.4 J2 Sense Connector Technical Information...........................................................................................36
3.11 Repackaging for Shipment .........................................................................................................36
CHAPTER 4: FRONT/REAR PANEL CONTROLS AND CONNECTORS
4.1 Introduction........................................................................................................................................37
4.2 Front Panel Display and Controls ..............................................................................................37
4.3 Rear Panel Connectors ................................................................................................................... 39
4.3.1 J1 Connector Terminal and Function .......................................................................................................... 41
4.3.2 J3 Connector Terminal and Function ......................................................................................................... 42
4.4 Front Panel Display Messages .....................................................................................................43
4.5 Navigating the Main Menu .......................................................................................................... 44
4.5.1 Introduction ................................................................................................................................................................44
4.5.2 Exiting the Main Menu ........................................................................................................................................44
4.6 Navigating Communication Menu ............................................................................................45
4.6.1 Introduction ................................................................................................................................................................ 45
4.6.2 Exiting the Communication Menu ..............................................................................................................46
4.7 Navigating the Protection Menu ................................................................................................ 46
4.7.1 Introduction ............................................................................................................................................................... 46
4.7.2 Exiting the Protection Menu.............................................................................................................................46
CHAPTER 5: LOCAL OPERATION
5.1 Introduction ........................................................................................................................................47
5.2 Standard Operation .........................................................................................................................47
5.2.1 Constant Voltage Mode and Voltage Setting ........................................................................................ 47
5.2.2 Constant Current Mode and Current Setting ........................................................................................ 47
5.2.3 Automatic Crossover .............................................................................................................................................48
5.2.4 Output On/Off Control ........................................................................................................................................48
5.2.5 Safe Start and Auto-Restart Modes .............................................................................................................. 48
5.2.6 Viewing Software Revision ................................................................................................................................48
5.3 Alarms and Protective Functions ................................................................................................49
5.3.1 Introduction ................................................................................................................................................................ 49
5.3.2 Over Voltage Protection ..................................................................................................................................... 49
5.3.2.1 Setting the OVP Level ....................................................................................................................................... 49
5.3.2.2 Resetting the OVP Circuit ...............................................................................................................................50
5.3.3 Under Voltage Protection and Under Voltage Limit ........................................................................ 50
5.3.3.1 Setting the UVP/UVL Mode and Level ....................................................................................................50
5.3.3.2 Activated UVP Alarm ......................................................................................................................................... 50
5.3.4 Foldback Protection ............................................................................................................................................. 50
5.3.4.1 Setting the Foldback Protection ............................................................................................................... 51
5.3.4.2 Activated FOLD Alarm ...................................................................................................................................... 51
5.3.5 Protection Delay ...................................................................................................................................................... 51