TDK-Lambda Z10-20 - Page 8

5.3.5.1 Setting the Protection Delay ........................................................................................................................ 51
5.3.6 Over Temperature Protection .......................................................................................................................... 51
5.3.7 AC Fail Alarm .............................................................................................................................................................. 51
5.4 Series Operation ............................................................................................................................... 52
5.4.1 Series Connection for Increased Output Voltage ................................................................................ 52
5.4.2 Series Connection for Positive and Negative Output Voltage .................................................... 52
5.4.3 Remote Programming in Series Operation .............................................................................................53
5.5 Parallel Operation ............................................................................................................................54
5.5.1 Introduction ................................................................................................................................................................54
5.5.2 Basic Parallel Operation .......................................................................................................................................54
5.5.2.1 Master Unit Set Up ..............................................................................................................................................54
5.5.2.2 Slave Unit Set Up ................................................................................................................................................. 55
5.5.2.3 Setting Over Voltage Protection ................................................................................................................ 55
5.5.2.4 Setting Foldback Protection ......................................................................................................................... 55
5.5.2.5 Connection to Load ........................................................................................................................................... 55
5.5.3 Advanced Parallel Operation ........................................................................................................................... 57
5.5.3.1 Setting Up of Master Unit ............................................................................................................................... 57
5.5.3.2 Setting Up of Slave Units ................................................................................................................................ 57
5.6 Daisy-Chain Connection ................................................................................................................58
5.7 Rear Panel (J3 Connector) Functions and Settings ..............................................................58
5.7.1 External Shut Off Function ................................................................................................................................. 59
5.7.2 Interlock Function - Analog On/Off. (Enable/Disable) ..................................................................... 59
5.7.3 Auxiliary Programmed Function Pin 1 and Pin 2 .................................................................................60
5.7.4 Power Supply OK Signal ...................................................................................................................................... 61
5.8 Rear Panel (J1 Connector) Functions .........................................................................................61
5.8.1 CV/CC Signal ............................................................................................................................................................... 61
5.9 Parameter Setting Memory .......................................................................................................... 62
5.9.1 Default Setting .......................................................................................................................................................... 62
5.9.2 Reset. ............................................................................................................................................................................... 62
5.9.3 Last Setting Memory ............................................................................................................................................. 62
5.9.4 Save .................................................................................................................................................................................. 63
5.9.5 Recall ............................................................................................................................................................................... 63
CHAPTER 6: REMOTE ANALOG PROGRAMMING
6.1 Introduction........................................................................................................................................65
6.2 Local/Remote Analog Control ..................................................................................................... 65
6.3 Local/Remote Analog Indication ................................................................................................65
6.4 Remote Voltage Programming of Output Voltage and Current .....................................66
6.5 Remote Resistor Programming of Output Voltage and Output Current ..................... 67
6.6 Programming Monitoring of Output Voltage (V_MON) and Current (I_MON) ........68
CHAPTER 7: Serial RS232/RS485 and USB Interface
7.1 Introduction ........................................................................................................................................ 69
7.2 Configuration .....................................................................................................................................69
7.2.1 Default Setting .......................................................................................................................................................... 69
7.2.2 Address Setting ........................................................................................................................................................ 69
7.2.3 Communication Interface Selection ..........................................................................................................69
7.2.4 Baud Rate Setting ....................................................................................................................................................70
7.2.5 Language Selection (RS232/RS485, USB) .................................................................................................. 70
7.2.6 Setting Unit in Remote, Local Lockout or Local Mode ..................................................................... 70
7.3 Rear Panel RS232/485 Connector ...............................................................................................71
7.4 Connectig Power Supply To RS232 Or RS485 BUS ................................................................72
7.5 Rear Panel USB Connector ............................................................................................................73
7.6 Multi Power Supply Connection to RS232 Or RS485 or USB ............................................. 73