Teac AG-V3020 - Playback and Memory Functions; Listening to Records and Compact Discs; Playing Tapes; Memory Scan Function

Ex.: Channel 20
ES!
al il
Mr
Ex.: Channel 30
Li} 3
A
ca
4. To release the memory function while the
MEMORY indicator flickers in the display, press the
UP or DOWN TUNING button.
@ Recalling Frequencies
Press the numeric key(s) corresponding to the channel
number to tune directly to a broadcast.
Note: After recalling preset channel 1 or 2, wait until
the stored band and frequency number appear
in the display before performing any other
function.
m@ Using the Memory Scan function
When the M.SCAN button (@) is pressed, the preset
channels in which data (bands and frequencies) have
been stored are scanned at five-second intervals in
numerical order of preset channels. When you hear a
broadcast you want to listen to, release the Memory
Scan function by pressing the M.SCAN button again.
Listening to Records and Compact Discs
POWER ON
= ee cs os ee
5@®M ooo
4 1
Turntable
fe)
re) 8
CD Player
1. Press the PHONO or CD button.
2. Play the turntable (with a moving magnet
cartridge) or CD player.
Playing Tapes : Pas
Note:
If two TEAC tape decks are used in the system, the
use of the UR-404 remote control unit may cause the
two decks to operate simultaneously.
POWER ON
7
fc)
Tape Deck 2 2
1. Set the TAPE 2 MONITOR button to ON; the TAPE
2 MON. indicator will appear in the display.
2. Operate tape deck 2 for playback.
@ Playing tape deck 1
To play tape deck 1, set the TAPE 2 MONITOR button
to OFF and press TAPE 1 button. Then operate tape
deck 1 for playback.
—16—