Teac AG-V3020 - Troubleshooting Continued; Surround Effects Issues; Remote Control Unit Issues

Problem
Probable Cause
No sound from the rear speakers.
SURROUND MODE switch is set to
BYPASS.
Set the switch to the desired
surround mode position.
When the MASTER VOLUME
setting is at low level, the volume
of the rear speakers becomes even
lower.
Increase the volume level of the
rear speakers using the REAR
LEVEL control.
No sound from the center speaker.
SURROUND MODE switch is not
set to PRO LOGIC or 3CH LOGIC.
Set the switch to PRO LOGIC or
3CH LOGIC.
When the MASTER VOLUME
setting is at low level, the volume
of the center speaker becomes
even lower.
Increase the volume level of the
center speaker using the CENTER
LEVEL control.
CENTER MODE switch is set to
Set the switch to NORMAL or WIDE.
PHANTOM.
Remote control impossible.
Caution:
The batteries are exhausted.
Replace with new batteries.
The remote control unit is too far
from the receiver or out of the
effective range.
Operate the remote control unit
within the effective range.
There is an obstacle between the
receiver's remote sensor and the
remote control unit.
Remove the obstacle.
Since
the
receiver
incorporates
a
microprocessor,
it
may
not
operate
correctly
because
of
external
noise,
etc.
If
this
happens,
disconnect
the
power
plug.
from
the
wall
outlet,
and
wait
approx.
ten
seconds,
reconnect
the
power
plug
then
turn
the POWER
switch
ON
and
restart
operations.
— 28 —