3. READ (X) AND RESET (Z) REPORTS EO1-11155
3.2 General Notes On Report Takings
3-19
EFT Batch
(1) Open Batch
An open batch command is sent to the EFT terminal to declare the use of the batch file.
This operation is performed before the store opens.
Example
• Operation: Mode Lock: X for read
Z for reset
When the ECR is being outside a sale and in Z mode, depress the
[↓] key twice to select “3 EFT(BATCH)”. And depress the [3] or
[Enter] key.
Select “1 OPEN BATCH”, then depress the [1] or [Enter] key.
The open batch is in process.
When the operation was successfully completed, this message is
displayed.
If it was failed, an error message is displayed. (NOTE 1)
Journal Print Format
OK: The operation was successfully completed.
NG: The operation was failed.
This message is printed when Open Batch has already been executed.
NOTE:
When a response from the EFT terminal was not sent correctly, an error message “RESPONS NG” is shown on
the LCD display.
When no response was sent from the EFT terminal within a specified time (standard: 30 seconds), a timeout
error occurs on the ECR and an error message “NO RESPONS” is shown on the LCD display.
OPEN BATCH
OK
9999 07:30TM
CLOSE BATCH
NG
BATCH ALREADY OEPNED
9999 07:30TM
To Next Page
Loading...
Need help?
General
