1. OPERATIONS IN “MGR” MODE EO1-11155
1.2 Other Operations Required Manager Interventions
1- 3
1.2 Other Operations Required Manager Interventions
Listing Capacity or Amount Limit Release
Amount Limits may be programmed on Departments/PLUs, Tender Medias, [DOLL DISC], [VND CPN], [STR
CPN]. These limits are programmed to check an excessively high or low amount entry by cashier’s mistake at
the earliest stage. Guide your cashiers as in the following procedure:
(1) During sale entries by the cashier, an error occurs with Error Message “OPERATION ERROR”
(programmable) is displayed.
(2) The cashier clears the error by the [C] key. The cashier confirms the amount and operates the item again.
(3) If the same error occurs again, the cashier attempts to enter the amount using the [OPEN] or [LC OPEN] key.
(4) If the operation results in an error again, the Amount Limit cannot be solved by the [OPEN] or [LC OPEN] key.
(5) The cashier calls for Manager Intervention.
The procedure thereafter is the same as Steps 2) to 7) for the Items Programmed to Require Manager
Interventions (Section 1.1).
In need of information of Amount Limits, ask your TOSHIBA TEC representative.
1.3 Post Authorization Operation
This operation is used for finalizing the EFT sale transaction which was authorized on the off-line ECR.
Any time outside a sale, In a Signed-ON condition
Mode Lock: MGR
• Without Card Number Entry
[POST AUTH] Card Slide |Sale Amount
| [#] |Authorization Code| [#]
Max. 7 digits Max. 11 characters
NOTE 1 (Omissible)
EFT terminal responds [STORE RECEIPT] Store Receipt Print
“APPROVAL”.
• With Card Number Entry
[MANUAL CARD#] [POST AUTH] |Card No.
| [#] (|Expiration Date|) [#]
Max. 25 digits Max. 4 digits; MM/YY
(Omissible)
|Sale Amount
| [#] (|Authorization Code|) [#] [STORE RECEIPT]
Max. 7 digits Max. 11 characters
(Omissible)
Store Receipt Print
OPERATION
To Next Page
Loading...
Need help?
General
