TEC MA-600-1 series - PLU Name Programming

4. PROGRAMMING OPERATIONS EO1-11155
4.13 PLU Name Programming
4-44
4.13 PLU Name Programming
A maximum of 16 characters of name of PLU which was programmed in the PLU Table Programming operation
is set here.
Any time outside a sale
Mode Lock: SET
1) Menu Tree
2) Operation Flowchart
NOTE: A maximum of 16 one-byte characters or 8 two-byte characters can be entered. A combination of
both types is also available.
OPERATION
CONDITION
[Enter]
[End]
“2 NAMES” is
selected.
Main Menu
“4 PLU (ITM NO.)
NAME
” is selected.
Select a PLU to be
programmed.
Input a PLU Name.
[Enter]
ECR is being outside a sale and in
SET
mode.
Depress
[
↓
]
then
[Enter]
.
Or Depress [2].
The ECR enters character input mode.
This setting is ended. A long receipt is issued
and the display returns to Main Menu screen.
Depress
[
↓
]
key three times then
[Enter]
.
Or Depress [4].
The PLU Name is entered
and
printed.
A maximum of 16 one
-byte or 8 two-
byte
characters are input.
Select a PLU of which name is to be
programmed with the [↑] or [↓] key.