14. OPERATING PROCEDURES
14.8 CALLING AND PRINTING LOGOS
14-13
14.8 CALLING AND PRINTING LOGOS
When the initial set #10-7 is set to “1” (or “2”: SL-9000N only), a logo containing a picture, a mark, a
POP message, etc., can be printed on the ingredient label having 12 lines or more.
Logo data is created on the PC and stored into the memory through the CMT/PL-3 interface.
Menu: REG., M.DOWN, or REWRAP
Mode: WEIGH, FIX, or BY COUNT
Enter the logo #.
(1 to 26 or 1 to 99)
1 0
LOGO
Start the label issue operation.
0
or C
Clear the entered
logo #.
PRT
Press:
Press:
NOTES: 1. The logo # will be effective until it is changed or deleted.
(Logo # is still effective after turning power off and/or changing mode.)
2. Pressing the key returns the display to the initial display of Weight mode.
This clears the unit price and tare data.
3. LOGOs will not be printed together with a safe handling instruction on a label.
4. LOGOs will be printed in the center of a label.
5. LOGO # “1 to 26” or “1 to 99” is selectable with the initial setting #10-7. (SL-
9000N only)
◇
Select the LOGO type
(LOGO (1) ↔ LOGO (2) ↔F.Shopper)
SL-9000N only
SL-9000N only
To Next Page
Loading...
Need help?
General
