16. ERROR MESSAGE TABLE
16. ERROR MESSAGE TABLE
16- 1
16. ERROR MESSAGE TABLE
Take the following action if an error message has appeared on the commodity name display along with
the buzzer sounding.
●
Programming Mode
Message Cause Solution
DATA ENTRY ERROR Error in key input. Press the key, and re-input the
right data.
MEMORY FULL No memory space to set PLU. Press the key, and delete
unnecessary PLUs.
DUPLICATE PLU The PLU # being changed is
already registered.
Press the key, and check the
PLU.
PLU NOT FOUND The PLU # being called out is
not registered.
Press the key, and set the data to
free PLU#.
CHARACTER OVERRUN Attempt is made to set more
than max. allowed number of
characters.
Press the key, and re-input the
right data.
PRT FAILURE DETECTED Printer trouble. 1. Check that the label and print head are
set correctly.
2. If the label home position is misaligned,
press the key.
LABEL OVERRUN Label overruns. Press the key.
RESTORE THE PLUS The capacity of RAM was
changed with the ingredient
data stored.
Press the key and save the
ingredient data. Then delete the data from
the memory of the unit. After that change
the capacity of RAM and load the data to
the unit.
If you annot solve the problem with the following solution instruction, do not attempt further
trouble shooting, by yourself. Turn the power off, unplug the printer, then contact your
Authorized Service representative for assistance.
Do not attempt to repair or adjust alone, because electrical equipment is dangerous.
WARNING!
To Next Page
Loading...
Need help?
General
