w w w . t e c h n i c o l o r . c o m / m c s
7.16 Using the COM46 REST Feature
REST feature send SOAP messages to a remote server for status monitoring via a
Representational State Transfer (REST) protocol. This feature requires a remote server able to
“catch” and store the REST messages. Contact Technicolor for more information.
Figure 36 - REST
7.17 Displaying COM2000 Status
By clicking the Display hyperlink at the top of any COM2000 web interface page, you can see the
information last obtained from a Discover or Refresh with the signal status of all cards in the
system as shown in Figure 37 below.
When used in conjunction with the Refresh commands, it simply filters the table so that all
discovered COM46 cards are shown at the top of the table and removes any system status
messages that may appear when running the previously covered functions.
Figure 37 - COM2000 Display Page
To Next Page
Need help?
General