Technics SA-DA10 Operating Instructions

RQT5518
22
2
1
3
4
5
12 345
DIGITAL
SPEAKERS
AB
BI-WIRE
INPUT SELECTOR
DIGITAL INPUT
DSP SOUND MODE
SPEAKERS
A
TAPE/MD
(TAPE)
VCR 1
CD DVD
VCR 2 TV
PHONO TUNER
S
PROGRAM FORMAT
SOUND MODE
SURROUND
LCR
LS S LFE RS
Enjoying the sounds
Preparation: Set [VOLUME] to the “MIN” position.
1 Press [ /l].
2 Select the speaker system(s) to be
used.
A, B and BI-WIRE refer to the speaker terminals at the rear
of the unit.
BI-WIRE and A, or BI-WIRE and B cannot be used at the
same time.
“SURROUND” and “SFC” cannot be turned on if [B] is
pressed.
If the button is pressed once more, the indicator will switch
off and no sound will be heard from the speakers.
3 Turn [INPUT SELECTOR] to select
desired source.
(Refer to the appropriate operating instructions for details.)
Each time the selector is turned the display switches.
Note
Turn on the TV and select the input mode to suit the source
(e.g. TV, VIDEO).
4
(only if you select TV, CD or DVD in the above step)
Press [DIGITAL INPUT] to select the
desired input mode.
Each time you press the button, the display switches as
follows.
DIGITAL ANALOG
The “DIGITAL” indicator lights when “DIGITAL” selected.
5 Press [DSP SOUND MODE] to select
the desired mode.
The SOUND MODE indicator corresponding to the selected
mode lights and that mode is displayed.
Note
¡Be sure to select the mode appropriate to the source you
are playing (a pages 20 and 21).
¡ Dolby Digital and DTS sources cannot be played with the
SFC modes.
(Continued on next page)

Technics SA-DA10 Specifications