Technics SA-DA10 Operating Instructions

RQT5518
30
2
A
4
2,4
MEMORY
PTY SEARCH
PTY SEARCH
MEMORY
M
M
M
The radio
Preset tuning
Presetting radio stations into the memory channels of this unit
makes selecting stations simple.
A total of 30 FM and AM stations can be preset.
Please remember this
If a new station is preset into a channel, the setting for the station
which was previously entered in that channel will be automatically
erased.
Automatic memory presetting
Automatic memory presetting allows this unit to search for
stations and then preset them into memory.
1 Tune to the lowest frequency in FM.
(a Pages 28 and 29.)
2 Press and hold [MEMORY, PTY
SEARCH] (for the United Kingdom) or
[MEMORY] (for Australia and New
Zealand).
Automatic memory presetting will start.
All the FM stations the unit can receive are preset in
channels 1 to 30.
3 Tune to the lowest frequency in AM.
(a Pages 28 and 29.)
4 Press and hold [MEMORY, PTY
SEARCH] (for the United Kingdom) or
[MEMORY] (for Australia and New
Zealand).
Automatic memory presetting will start.
All the AM stations the unit can receive are preset in
channels 21 to 30. (Any FM stations in these channels will
be replaced.)
During automatic memory presetting, the memory indicator
will flash while the frequency scrolls.
When a station is preset
The memory indicator and the preset channel number will
be displayed for approximately 1 second.(Å)
When presetting is completed
The last station to be preset will be displayed.
Note
Frequencies may not be preset correctly in cases where the
broadcast waves are too strong or too weak. In such cases, carry
out presetting manually (a page 31).

Technics SA-DA10 Specifications