Program play
button
1
Press the numeric button(s) to specify the
desired track.
The specified track is shown on the track display
2
Press the memory button.
Repeat steps 1 and 2 until the desired
programming (up to 20 tracks) is completed.
3
Press the play button.
Play begins from the first programmed track.
After the last programmed track has been played, the unit
switches to the stop mode.
t
-------
0
L---l
g -!
0
---------------_-----------
I%
0
Specifi track3
S&y track 5
I Dl8”
q’,frg*Qj
Specify track 1
W/hen the play button is pressed. play begins from track 3.
No@:
0” t ” (error) is displayed momentarily if a track number not on
the disc is specified.
If more than 20 selections are entered “F ” (full) is shown in the
display panel and no further selections can be programmed.
.Programming two tracks in a row:
For example, if tracks 3-5-5-l are programmed in that order,
press the memory button twice. after pressing
q
.
To clear a program entry
(When the unit is in the stop mode)
H Press the clear button.
Each time the clear button is pressed. the last track in the
programmed sequence is cancelled.
Note:
If the clear button is pressed during program play, all memory
contents are cleared and disc play continues from the current
point to the end of the disc (Memory clear function).
To Next Page
Loading...
