Technifor XF510Cr - Measured Noise Emission Levels and Safety

ANoise emission of the machine
F
Ref. DCD01/3074 - XF510Cr-Sr-Dr_en_C
30/31
2. Noise emission information
The values given below represent the noise emitted by the machine during marking. When the machine is in use,
the values mentioned are independent from the total noise level to which the operator is exposed, since the actual
noise level will vary depending on the operator’s environment.
Similar results for XF510Cr/Dr machines.
Position
L
Aeq
(L
Aeq
= "equivalent" average sound
level measured using the A-
weighting)
L
pc
(L
pc
= peak acoustic pressure level)
1 78 dB(A) 88 dB(C)
2 74 dB(A) 85.5 dB(C)
3 71 dB(A) 80 dB(C)
When marking resonant parts (metallic, hollow, thin), wear hearing protection for
sound levels L
Aeq
> 85 dB(A) or L
pc
> 137 dB(C).