56
Call: 1-631-648-7481 or Visit: support.technocnc.com
Titan Series WinCNC Manual
WinCNC
WinCNC Controller
WinCNC Users Guide Page 96
L35 AutoAuxOut Disable - L35 D#
Disables the auxiliary output that is turned on by the L34 com-
mand. L35 D# sets the dwell time in seconds when the channel is
set to off. When the ‘D’ parameter is used with the L35 command
the “AutoAuxOut” mode does not change.
L36 Torch Height Control On.
L36.1 Auto Voltage Set Mode On.
L36.2 Reset Auto Voltage Set Status.
L37 Torch Height Control Off.
L37.1 Auto Voltage Set Mode Off.
L38 Torch On.
L39 Torch Off.
L40 Feed Rate Override - L40 P#
Allows user to set the feed rate override by command. P must be
within the bounds specied in the INI le. If not, the command is
ignored. The L40 command without a P# resets the feed rate to
the default.
L41 Shell Command - L41 C:\Path\Program.exe
Allows the user to run an executable program from within WinCNC.
NOTE: There is no error reporting for this command. If the path or
lename are incorrect the command will fail without aborting.
L48 Laser Height Control
Sets the target voltage to the current input voltage.
L51 Set D/A - L51 V# P# S#
Sets the output voltage for DA. The V parameter is used to set the
DA by voltage, the P to set the DA by a Percentage, and the S is
used to set the DA by spindle speed. ONLY 1 PARAMETER CAN
BE USED.
L53 Set Vertical Head Height
Raises all vertical heads as high as possible while keeping the bits
at equal height.
To Next Page
Loading...
