Techno CNC Systems 60120 - Page 63

63
Call: 1-631-648-7481 or Visit: support.technocnc.com
Titan Series WinCNC Manual
WinCNC
WinCNC Controller
WinCNC Users Guide Page 103
L600 Disable Mapping Adjustments
Disable mapping adjustment for the specied axis. If no axis is
specied, mapping adjustments for all axes are disabled.
L601 Enable Mapping Adjustments
Enable mapping adjustment for the specied axis. If no axis is
specied, mapping adjustments for all axes are enabled.
L602 Start Mapping Setup
Starts mapping setup for specied axis. First axis species the axis
to map and the second axis species the axis to adjust. The axis
map will automatically move to the start map position. No axis spec
stops the mapping setup.
L603 Store Current Adjustment and Move - L603 {NPSE}
Stores the current adjustment and moves the map axis to the
specied map increment. N is next, P is previous, S is start, and E
is end. The default move is to the next map increment position.
L604 Move Map Axis By Increment - L604 {NPSE}
Moves the map axis to the specied map increment. N is next, P is
previous, S is start, and E is end. The default move is to the next
map increment position.
L605 Store Current Adjustment
Stores the current adjustment.
L800 Disable Probe
Disables the probe.
L801 Enable Probe
Enables the probe.
When probe is enabled (L801) it acts similarly to a limit switch.
When it comes in contact with an object, it will stop motion. If it is
disabled (L800) it no longer functions.
Command Reference