EXCITE/EXCITE+ LINE - ASSEMBLY KIT VISIO/VISIOWEB-UNITY3.0
Installation Manual UNITY 3.0- Rev. 1.0
e-mail: support@technogym.com
Pag. 21
4. RUN NOW / JOG NOW: UNITY 3.0 INSTALLATION INSTRUCTIONS
The following procedure describes the UNITY 3.0 installation steps on the Run Now equipment.
This procedure is applicable also to the JOG NOW equipment.
ESTIMATED TIME: 1h. and 15minutes. N° of TECHNICIANS NEEDED: 1.
All Assembly Kits include the UNITY 3.0 assembled with black frame. In addition, the kit contains
the grey frame. Before mounting the display, ask the customer if he wants the black or grey frame. If
necessary, replace the frame.
4.1 DISASSEMBLING THE UPPER GUARD OF THE LOW KIT
1.Lift up the machine at the elevation of 10%, to
make the procedure easier.
2.Turn o the machine. Unplug the
mains lead from the wall outlet.
3. Loosen the 5 screws (B) using a 4mm hexa-
gonal wrench.
4. Remove the upper guard (C) pulling it out
from the front side of the machine.
To Next Page
Loading...
