EXCITE/EXCITE+ LINE - ASSEMBLY KIT VISIO/VISIOWEB-UNITY3.0
Installation Manual UNITY 3.0- Rev. 1.0
e-mail: support@technogym.com
Pag. 19
3.4 REASSEMBLING THE DISPLAY
Reposition the display following the steps described at the Paragraph “3.1 disassembling the di-
splay”, in reverse order.
3.5 LOW KIT REPLACEMENT
Replace the Low Kit with the one provided in the Assembly Kit. The disassembling procedure is
described in the Technical Service guides, available on TG Direct.
3.6 UNITY 3.0 SW AND LOW KIT FW UPDATE
1. Connect the power cable to the power outlet and switch on the equipment.
2. Update the UNITY 3.0 SW, using the UNITY upgrade USB key, as soon as synchronized with
PC Synch.
3. Update the FW of the Low Kit.
3.7 UNITY 3.0 CONFIGURATION
For details, see the UNITY 3.0 User Interfaces & SW Upgrade Manual, available on TG Direct.
To Next Page
Loading...
