Technogym Personal Selection TUV - The Sliding Bars of the Leg Press Seat Are Not Aligned

Personal Selection TÜV: Service & Maintenance Manual - rev. 1.0
Page 5.6
5.5. THE SLIDING BARS OF THE LEG PRESS SEAT ARE NOT
ALIGNED
To align the sliding bars of the seat, you may adjust the position as illustrated below:
Photo 5.5-1
1. Remove the seat as described in paragraph
6.5. “Leg Press Seat”.
For each bar:
2. Remove the protective caps at the ends of the
bars.
3. Loosen the screw a using a 14-gauge
hexagonal T-wrench.
Photo 5.5-2
4. Loosen the screw b using a 14-gauge
hexagonal T-wrench.
5. Turn the bar until it is perfectly aligned.